What are the precautions for filling machine maintenance in summer?

　　Filling machines are mainly a small category of products in packaging machines. From the perspective of packaging materials, they can be divided into liquid filling machines, paste filling machines, powder filling machines, and particle filling machines; from the degree of automation of production It is divided into semi-automatic filling machine and fully automatic filling production line. Recently, with the QS certification of food, edible oil manufacturers have begun to pay attention to product quality and packaging, so the oil filling machine has a prominent position in the filling machine. The weather is getting hotter and hotter recently, but we still have to keep working. GST is here to share with you some precautions about the maintenance of filling machines in summer, hoping to provide you with some references.

　　Before talking about the maintenance of the filling machine, GST believes that it is necessary to know the operation method of the filling machine!

　　Check before use: After the machine is installed, turn on the power, test run the motor, ensure the correct direction of operation, ensure the pressure and flow of compressed air, check whether the motors, bearings, etc. need to add lubricating oil, it is strictly forbidden to run without oil, and only after it is normal Start the machine, and at the same time observe whether the fasteners in each part are loose. After the operation of each part is stable, it can be used normally.

　　Safety inspection: Check whether the safety facilities are functioning normally.

　　Before starting the machine: carefully check whether there is water in all water tanks, whether the chain plates are stuck, whether there are sundries on the conveyor belt, whether there are bottle caps in the lid storage box, whether the water source, power supply, and air source are connected.

　　The conditions are ready: after all the conditions are ready, turn on the main power supply, the power indicator light is on, the fault indicator light and the emergency stop indicator light are not on, then the starting conditions are met, press the start button on the control box and the filling place to start switch, the whole machine starts to run, and enters the automatic working mode of washing, rinsing and filling. To stop, press the stop button at the filling place and the control box. After stopping, the main power should be turned off.

　　What are the precautions for filling machine maintenance in summer?

　　1. Always disinfect the filling machine, especially in the beverage industry. When using the filling machine, you must pay attention to disinfection and avoid reducing the entry of oxygen. Always keep the filling machine pipeline clean. Pipelines in direct contact with materials must be kept clean, at least once a week.

　　2. Open the main box and clean the oil and other sundries in the box.

　　3. Check the fastening conditions of each fastening part one by one, and immediately carry out fastening treatment if looseness is found.

　　4. Lubricate the filling mechanism and each sliding mechanism with lubricating oil.

　　5. Check the wear condition of the synchronous belt of the motor, replace the damaged synchronous belt, and adjust the tensioning mechanism of the transmission belt to make it appropriate in size.

　　6. Check the washer of the triangular fixture, and replace it if damaged.

　　The above are some precautions about the maintenance of the filling machine in summer that GST shared with you. After reading it, do you have a certain understanding of the cleaning of the equipment?