How to make good use of the fully automatic labeling machine?

　　GST automatic labeling machine manufacturers explain how to make good use of the labeling machine? Many friends do not know much about the use of labeling machines. In fact, for the operation of this type of machine, we only need to make some adjustments to the machine and remember the machine clearly. The operation and use steps can be easily used, so how to use the labeling machine well?

　　1. First of all, we need to do a good job in the settings of the labeling machine

　　The distance from the peel plate to the bottle should be minimized.

　　The pre-mark distance should be reduced. Note that this will cause the labelling machine to change in style, for example, the pressure belt type requires more pre-gauge than the scraper type (consult the labeler supplier for details).

　　If PET backing paper/transparent surface material is used, label positioning sensors suitable for transparent materials, such as ultrasonic sensors or capacitive sensors, are required.

　　When the label first contacts the surface of the bottle, it is necessary to apply pressure simultaneously to ensure that all the air under the label is expelled, thereby avoiding air bubbles and wrinkles. "It is not recommended to touch the label after labeling."

　　In some cases, such as carton labeling, inline labelers use brushes and low-density foam rollers to apply the labels. However, for pressure-sensitive label applications, such as film labels on glass/plastic/wine bottles, brushes and low-density foam pressing rollers are not recommended, because the labeling requirements at this time are to achieve no bubbles on the labeling surface, no air ruffled. These devices do not apply enough pressure on the label surface to completely expel the air under the label.

　　Slowly apply enough pressure from the edge of the label to the trailing edge to ensure that the label is truly "adherent".

　　2. The steps of using the labeling machine

　　Turn on the main power switch. Turn on the power switch on the left side of the labeling machine. After the labeling machine is turned on, enter the password on the touch screen to enter the system. After the label paper is installed on the labeling machine, various parameters can be adjusted through the touch screen. Debug the position of the electric eye of the object to be measured, and adjust the sensitivity of the electric eye of the target. Adjust the appropriate speed. The labeling position is adjusted to ensure that the peeling part of the label is aligned with the labeling position. Press the run button and the system runs. Remember to shut down and turn off the power supply after the labeling machine is normally used.