Operation method of automatic filling machine

　　Automatic filling machines are often used for liquid filling, such as: detergents, glass water antifreeze, lubricating oils, edible oils, mineral water, beverages, etc. Qingzhou Lutai Machinery automatic filling machines are commonly used in industry Mechanical equipment, making a set of process rules. Only when the filling machine is operated correctly can it be produced safely. ‍

　　Operation method of automatic filling machine:

　　1. Check before use: Before starting the machine, make sure that the power plug of the filling machine is connected to the 380V power supply and the ground wire of the machine chassis. Make sure that the air pressure on the filling machine is 0.05~0.07Mpa. Check whether each motor, bearing, etc. need to be lubricated. It is strictly forbidden to run without oil. The machine can be started only after normal operation. At the same time, observe whether there are material chain plates in all liquid storage tanks. Are there any debris storage caps on the conveyor belt? Are there bottle caps in the track? Are the water, power, and gas sources connected to all liquid storage tanks? Are there material chain plates stuck on the conveyor belt? Is there any debris storage caps on the conveyor belt? Are there bottle caps in the track? Check whether the water source, power supply, and gas source are connected, and whether the fasteners in each part are loose, and can only be used normally after the operation of each part is stable.

　　2. Check whether the safety facilities are functioning properly. Make sure that the valve of the reaction tank and the pipeline of the filter unit are tightly connected, the filter cloth of the filter unit is intact, and the cover is covered with the tightening bolts to ensure that there is no leakage under the packaging pressure. Check all the connection lines related to the filling machine to ensure that there are no broken skins and no short circuits and other faults.

　　3. Before starting the machine, carefully check whether all the water tanks have water, whether the chain plates are stuck, whether there are sundries on the conveyor belt, whether there are bottle caps in the storage cover box, whether the water source, power supply, and gas source are connected, and prepare for various conditions. After that, turn on the main power QF, the power indicator is on, the fault indicator and emergency stop indicator are not on, then the starting conditions are met, press the start button on the control box and the start switch at the filling place, and the buzzer will sound three times. After the warning, the whole machine starts running and enters the fully automatic working mode of external washing, flushing and filling. When the machine stops, press the stop button at the filling place and the control box. After stopping, the main power should be turned off. ‍