How to solve the problem of vacuum level in the operation of blister machine

　　Blister machine is a kind of low investment, a wide range of molding equipment, simple workflow, simple maintenance, but inevitably there will be some small failures in the operation, in the vacuum degree is not up how to solve the situation?

　　First from the suction machine air circuit, vacuum pump motor belt, solenoid valve, vacuum table four places to check, common problems have suction machine air circuit blockage, vacuum pump motor belt is not tight, solenoid valve is in the open state, vacuum table does not work, these problems are not solved, will make the suction machine work unstable, easy to appear inferior.

　　Solution: keep the air line of the blister machine open; close the solenoid valve of the blister machine; tighten the vacuum pump motor belt; replace the blister machine with a high quality vacuum table installed.

　　The above is the solution to the vacuum of the blister machine can not come up, when using the blister machine, to regularly check the blister machine, the correct operation, can improve the efficiency of the blister machine, reduce maintenance costs.

　　Features of vacuum blister machine.

　　1. Vertical pulling sheet design, pulling sheet quickly and steadily, more adaptable to environmental protection materials, to ensure the quality of product forming.

　　2. Adopt special hair piece assembly, the temperature is even, and save 50% electricity than traditional machine.

　　3. Electric heating furnace adopts closed heating to reduce heat loss, manual switch to control electric heating furnace, thick film can be heated by double electric furnaces on top and bottom, fast heating time to improve production speed.

　　4. The blister machine is equipped with vibrating de-filming device, which makes the product not easy to deform and easy to demould.

　　5. Double rows of pointed needle chain drive ensure the stability and accuracy of the blister machine, and the width adjustable device can make maximum use of the film and reduce waste.

　　6. Equipped with water cooling device and high speed cold water spray to speed up the molding speed, which is twice of the traditional speed.

　　7. Built-in secondary vacuum, forming easier, improving quality and reducing scrap rate.

　　The above is a detailed introduction about how to solve the problem of vacuum not coming up in the operation of the blister machine, I hope the above will be helpful to you.